In short
If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Paramus realigns or replaces the sensors and tests the safety reverse.

Doors that won't close in Paramus
Almost all of Paramus is post-war single-family housing, and many of those one-car garages have been in continuous use for seventy years. The sensors were added later, usually on the original wood jambs, and they sit at bumper height for a modern SUV squeezing in. In Arcola and Spring Valley, the usual call is a bracket bent a few degrees. Near the Saddle River, damp and the odd high-water event corrode the wire ends. A steady light on both sides tells you the beam is fine.
What it means when the door won't go down
Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.
- Blinking sensor light: the eyes are out of line or one lens is dirty.
- Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
- Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.
What you can safely try yourself
Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.
Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.
What the technician does
- Checks power and wiring to both sensors and repairs any break.
- Realigns the sensors, or replaces the pair if one has failed.
- Resets the open and close travel so the door seals without straining.
- Tests the automatic reverse on an object in the doorway and with the beam blocked.
Around Paramus
- Farview Avenue area: West-side neighborhoods between Route 17 and Ridgewood.
- Midland Avenue area: Central streets with many expanded capes.
See the full Paramus service area.